Background:  When rebooting Linux OS, loadable drivers are not automatically reloaded.  Drivers may be obtained from MaxLinear / Exar website:
https://www.exar.com/design-tools/software-drivers
Once compiled on the Linux system, the drivers may be made persistent by the following directions for Linux CentOS. For Ubuntu and other distributions, these directions do not apply. 

Note that in more recent kernel distributions, a native serial driver is built in the Linux kernel and is automatically loaded and may be used for basic functionality of the PCI / PCIe UARTs. For full functionality of our UARTs, the custom driver must be loaded, but the serial driver must first be unbound.

Following changes to kernel allow PCI / PCIe drivers to automatically load in Ubuntu at start-up.

1.1.  Confirm if the native seral driver is loaded:
a.lspci -vd 13a8:*
b.You may see something like:  
03:00.0 Serial controller: Exar Corp. Device 0358 (rev 03) (prog-if 02 [16550])
Flags: fast devsel, IRQ 30
Memory at f3ffc000 (32-bit, non-prefetchable) [size=16K]
Capabilities: [50] MSI: Enable- Count=1/1 Maskable- 64bit+
Capabilities: [78] Power Management version 3
Capabilities: [80] Express Endpoint, MSI 01
Capabilities: [100] Virtual Channel
Kernel driver in use: serial
c.If the Kernel driver in use: is serial, complete all remaining steps.  If not, skip to step 2b.
d.ls /sys/bus/pci/drivers/serial/
e.You should see something like:  
0000:03:00.0 bind new_id remove_id uevent unbind
f.Unbind the serial driver (replacing value with value from 1e above):
echo -n 0000:03:00.0 > /sys/bus/pci/drivers/serial/unbind

2.  Copy xr17v35x.ko to /lib/modules/(linux kernel version)/kernel/drivers/char

cp xr17v35x.ko /lib/modules/3.0.0-generic/kernel/drivers/char/

2. Run depmod and modprobe

depmod -a
modprobe xr17v35x

3. Edit /etc/modules file and add 'xr17v35x' string in a new line at the end of the file

4. Save /etc/modules and reboot.

5. Confirm that after reboot, ports show up as /dev/ttyXR*



